LiftMaster operators
Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gatesFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateLiftMaster Keypad & Intercom Repair: The Boulder City Owner’s Guide
LiftMaster keypad and intercom repair in Boulder City typically runs $185 to $420 installed for a keypad, and $240 to $560 for intercom and entry-panel work, depending on the model and whether the low-voltage wiring is sound. We handle this as a repair service, not a sales call: the failed part gets matched to your unit, the price goes in writing, and most straightforward keypad swaps are done the same day you call. The intercom side can take longer if we’re waiting on a board or a station that has to be ordered. Boulder City’s dry desert air and summer heat do a number on outdoor keypads, so we see a specific pattern of failure here that you won’t run into in wetter climates. You usually discover the problem the same way: the code stops working, the gate refuses to open from the pedestal, or the intercom crackles and then goes silent.
Key Takeaways
- Most LiftMaster keypad replacements land between $185 and $420 installed.
- Intercom and entry-station repairs run $240 to $560 installed, with parts ordered for older models.
- Same-day service on keypad swaps; intercom diagnosis may need a scheduled return visit.
- You get a written price before any work starts, plus a photo record of what was found and what was replaced.
Which LiftMaster Models This Applies To
LiftMaster keypads and intercoms show up across a few distinct product families, and the part you need depends entirely on which one is on your post. The standalone wireless keypads (think the 878MAX and 877MAX lines) are the simplest case: they’re self-contained, battery-powered, transmitter-style units that talk to the opener or receiver. The wired keypads and the Elite-series access controls sit on a low-voltage circuit and often share a communications bus with the operator. Intercom and entry panels (the LMR, LMM, and their station variants) are a different animal, with their own two-wire or four-wire runs and station addressing that has to match the master.
To identify yours, read the model label on the back of the keypad faceplate or inside the intercom housing, and note the wire count at the terminal block. That second detail matters more than the label in older installs, because LiftMaster changed terminal layouts across generations and the label numbers alone can mislead. On the OEM-versus-aftermarket call: for common wireless keypads, a quality compatible unit is a reasonable path and often what we’d quote. For wired Elite controls and intercom stations where addressing or the bus protocol matters, the OEM part avoids a compatibility fight. We’re an independent service provider and not affiliated with LiftMaster, so our recommendation follows what actually works on your gate, not what’s easiest to sell.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Signs Your LiftMaster Keypad & Intercom Repair Is Failing

- The code works intermittently, then stops. On outdoor wireless keypads this is almost always the battery contacts corroding from dust and heat, or a membrane keypad failing under UV. Boulder City’s sun cooks plastic faceplates faster than most owners expect.
- The intercom crackles, hums, or drops to one-way audio. Usually a degraded station speaker or a loose connection on the low-voltage run. A single water-damaged splice in the conduit can pull the whole station down.
- The gate won’t respond from the pedestal, but the remote works fine. That points to the keypad’s transmitter board or its pairing with the receiver, not the operator. The remote testing clean is the tell.
- The keypad backlight is dead but the buttons still click. Power delivery is failing on a wired unit, often at the terminal or a buried wire nick. This one needs a meter, not a guess.
- The intercom rings nothing at the house station. A station-address mismatch or a failed master board. On older LMM setups this shows up after a power event, when the addressing resets.
Before
AfterReplacement Cost & What’s Included
Here’s the Boulder City pricing picture, installed, with the part included and the price written before we start under The Haven Standard.
| Scope of work | Installed range |
|---|---|
| Wireless keypad replacement (battery, self-contained) | $185 – $280 |
| Wired keypad replacement with terminal re-termination | $240 – $380 |
| Intercom station or speaker repair | $240 – $420 |
| Entry-panel / master board work | $360 – $560 |
| Low-voltage wire trace or repair (if fault is in the run) | Add $95 – $220 |
What drives the range: whether the part is common or has to be ordered for an older model, whether the low-voltage wiring is intact, and whether the fault is the keypad itself or the operator’s receiver. Every job gets the written flat price first, a photographic record of what was found and what was set, and coverage under our 365-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?

There’s an honest split here. An owner can safely replace the batteries in a wireless keypad, check that the keypad’s circuit breaker or low-voltage feed is live, and confirm the remote still operates the gate (which tells you the operator is fine and the fault is at the pedestal). Those checks cost nothing and rule out the easy stuff.
Where DIY goes wrong: on wired keypads and intercom panels, the low-voltage wiring carries signaling that is sensitive to a swapped terminal, and a miswired station or reversed polarity can take out a board that costs more than the whole repair. On any intercom that ties into an existing access-control loop, this is not a job to learn on. LiftMaster intercom wiring is low voltage, not line voltage, but the risk is to the equipment and to the fire-safety interlocks that some gates carry. So check the batteries, confirm the remote, and call us for the rest. Estimates are free, and a live person answers around the clock. Call (844) 320-7587.
FAQs
An outdoor wireless keypad here typically lasts 3 to 6 years before the UV and dust wear out the buttons and contacts, and wired units can go 8 to 12 years if the wiring is protected. Boulder City’s heat and sun shorten outdoor keypad life compared to cooler climates, so factoring a shorter lifespan into your budget is fair.
Sometimes yes. Intercom station faults are often a speaker or a loose splice that we can repair without changing the whole unit, and a dead wired keypad can be a bad terminal rather than a dead keypad. We diagnose first, quote the repair, and only recommend a replacement when the repair won’t hold. Call (844) 320-7587 for a free estimate.
A wireless keypad swap is usually 30 to 45 minutes once we’re on site; a wired keypad or intercom repair takes 1 to 2 hours depending on the wiring fault. When a part has to be ordered for an older model, we schedule the return around the part’s arrival rather than guess a date. Call (844) 320-7587 and we’ll confirm what your unit needs.
We match the model and generation of your LiftMaster unit, then quote the OEM part or a quality compatible equivalent depending on what’s on your gate. We don’t carry stock and don’t claim parts on a truck; we order what fits and record the part number installed in your photo log. Call (844) 320-7587 for a written price.
Ready for a Written Price?

If your LiftMaster keypad or intercom in Boulder City has stopped working the way it should, we’ll diagnose it, hand you a written flat price before any tool comes out, and leave you a photographic record of the whole job. We also service Mighty Mule, Ghost Controls, DoorKing, and other major gate-automation brands, so whatever motor is on your property, one call covers it. A live person answers the phone 24 hours a day, every day. Call (844) 320-7587 for a free estimate on your Boulder City keypad or intercom repair.
Written by the team at Vance Gate Repair Boulder City, serving Boulder City and nearby areas.