Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGhost Controls Gate Motor & Opener in Boulder City: What to Know First
We service and repair Ghost Controls gate motors and openers in Boulder City as an independent Ghost Controls service provider, and most residential swing-gate repairs are finished in a single visit, usually within a few days of your call. Solar and battery-backup systems, the ones Ghost Controls built its reputation on, get the same treatment as any AC-powered unit: diagnosed in person, priced in writing before we touch a tool, and documented with photos when we leave. We don’t publish a “call for a quote” line. The written price comes first, and it should.
This page is for the homeowner who already knows their opener is a Ghost Controls and wants to understand what’s actually wrong before anyone shows up. Call (844) 320-7587 and a live person answers, day or night.
How Ghost Controls Products Fail – and How We Fix Them
Ghost Controls units fail in ways that are different from a LiftMaster or a Linear, and the diagnosis has to match the brand. Here’s what we see most often on Boulder City gates.
- Battery bank drops below usable voltage after a cold snap. Ghost Controls solar and battery-backup models (the TSS1 and similar tube-slide kits) run off a sealed battery that a homeowner rarely thinks about until the gate stops. Boulder City’s desert nights swing 30 degrees or more between afternoon and dawn, and a battery already two winters old will read fine at noon and fail to cycle the gate at 6 a.m. We load-test the battery under a real cycle, not just a voltmeter, before we sell you a new one.
- The control board cooks in a steel or brick pillar. Ghost Controls boards are sealed, but they still sit inside the operator housing, and a south-facing block pillar in Boulder City summer heat will push internal temps past what the board wants. The symptom is a gate that opens without being told or stops mid-travel for no reason. We photograph the board, check for heat discoloration, and tell you honestly whether a board replacement is the fix or whether the housing needs shade or ventilation first.
- Limit switches drift out of position. The limit switch is the sensor that tells the motor where the gate should stop. On Ghost Controls arms it’s a mechanical set-point that walks out of alignment over a season of heat cycling. When the gate stops short or slams the post, that switch is the first thing we check – and we photograph the exact degree position after we reset it so the next tech doesn’t have to guess.
- Arm bracket loosens and the gate sags into the motor. A Ghost Controls arm bolted to a wood post or a thin steel frame will work itself loose as the gate swings. Left alone, that misalignment eats the gear and the arm itself. We re-level the bracket, torque it to spec, and check the gate’s hinge side before we call the motor fixed.
- Photo-eye misalignment or a failed safety edge. The photo-eye is the infrared beam that stops the gate if something crosses the path; the safety edge is the rubber strip on the gate leaf. Either one failing puts a Ghost Controls unit into a fault that looks like a dead motor. We test both, realign or replace, and document the correction.
One detail worth knowing: Ghost Controls doesn’t sell its boards and arms through every distributor, and aftermarket replacements that “fit” often don’t match the original connector pinout. We source OEM where the part is still in production and tell you plainly when an aftermarket part is a genuine match versus a gamble.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Ghost Controls Gate Motor & Opener Process

- 1
Call and intake. A live person takes the call at any hour. We ask the model, the gate type (swing or slide), whether it’s solar or AC, and what the gate is doing – or not doing.
- 2
On-site diagnosis. We test the battery under load, the control board, the limits, the photo-eye, and the safety edge. This is where the Haven Standard kicks in: we find the actual failure, not the loudest symptom.
- 3
Written price before any work. You get a flat written price covering the diagnosis, the part, and the labor, handed to you before a tool comes out of the case. OEM-versus-aftermarket is spelled out in the same document.
- 4
The repair or replacement. We install the part, re-torque the arm bracket, and reset the limits to the gate’s real travel.
- 5
Full cycle test. We run the gate through open, close, obstacle reversal, and manual release before we consider it done.
- 6
Documentation. You get a photo log of what was found, what was set, and the part number installed, filed in the job record. The 365-Day Done Right Promise backs the work for a full year.
Before
AfterWhat Ghost Controls Gate Motor & Opener Costs in Boulder City
Here’s what Ghost Controls work typically runs in Boulder City, with the honest caveat that the written quote you get on-site is the number that matters:
| Job | Typical Range |
|---|---|
| Diagnostic visit (credited toward repair) | $95 – $145 |
| Battery replacement, solar/backup models | $180 – $320 |
| Limit switch reset and arm re-torque | $150 – $260 |
| Control board replacement | $320 – $520 |
| Full arm/motor replacement (Ghost Controls swing or slide) | $650 – $1,100 |
| Photo-eye or safety edge repair | $140 – $240 |
What moves the price: whether the part is OEM or quality aftermarket, whether the gate itself needs hinge or bracket work before the motor will run true, and whether you’re on solar versus AC. The quote is written and agreed before any work starts – our Haven Standard Clause 1 makes that non-negotiable. Estimates are free, so call (844) 320-7587 for an exact quote on your Ghost Controls unit.
See the difference
Before
After
Before
After
Before
AfterWhy Boulder City Homeowners Call Vance Gate Repair Boulder City for Ghost Controls Work

We work on nine gate-automation brands, and Ghost Controls is one of them. That matters if your property also has a LiftMaster on one gate and a Ghost Controls on another, or if you’re weighing repair versus replacing with a Mighty Mule or DoorKing unit – one company can service whatever motor is already bolted to the post instead of steering you toward a swap. Every job leaves a photographed record of what we found and what we changed, and the 365-Day Done Right Promise gives you a full year for us to make any repair right at no additional charge. A live person answers the phone 24 hours a day. Our technicians have up to 12 years of experience, and they document like it.
FAQs
Will servicing my Ghost Controls unit void the manufacturer warranty? No – professional diagnosis and repair with OEM parts is exactly what the warranty expects. We’re an independent service provider, not affiliated with or authorized by Ghost Controls, but we source OEM where the part is in production and document everything with photos and part numbers so you have a paper trail if a warranty claim ever comes up.
Can you get Ghost Controls parts in Boulder City? Usually, yes – most common parts (boards, arms, batteries, photo-eyes) are orderable within days, and many are on a service visit same or next day. When a part is out of production or backordered, we tell you upfront and quote the OEM-compatible aftermarket option with a note on how it differs.
Should I repair or replace my Ghost Controls motor? Repair when the board, battery, or limits are the failure and the housing and arm are sound – that’s most jobs. Replace when the arm gear is stripped, the housing has heat damage, or the gate itself has changed and the motor can’t match it. We’ll quote both and let you decide; we don’t steer toward replacement when repair is the honest call.
How fast can you get to a Ghost Controls gate in Boulder City? Most residential repairs are scheduled within a few days, and emergency calls get priority. A live person answers at any hour – call (844) 320-7587 and we’ll tell you honestly what the soonest slot is.
Do you service solar and battery-backup Ghost Controls systems? Yes – solar and battery-backup models are the bulk of Ghost Controls installs in Boulder City’s open-desert properties, and we load-test the battery under real cycle before recommending a replacement. A battery that reads fine on a voltmeter can still fail under the motor’s draw.
Written by the team at Vance Gate Repair Boulder City, serving Boulder City and nearby areas.
Contact Vance Gate Repair Boulder City

If your Ghost Controls gate is stopped, sluggish, opening on its own, or just not behaving the way it used to, call (844) 320-7587 for a free estimate. A live person answers day or night, the written price comes before any work starts, and every visit leaves a documented record behind – so you’re not paying twice to rediscover the same problem. Independent Ghost Controls service provider. LiftMaster, Mighty Mule, and DoorKing serviced too.