Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
See the difference
Before
After
Before
After
Before
AfterGate Realignment in Boulder City, NV
Gate realignment in Boulder City, NV typically runs $150 to $450, and most jobs are finished in a single visit. Realignment means bringing the gate back to true: adjusting hinges, resetting the post or frame, correcting the sag, and re-tuning the opener’s limit switches so the gate travels fully and closes flush. It’s the fix for a gate that drags on the ground, rubs the post, or hums partway open and stops.
We do this work with a written price in hand before anyone picks up a tool, and we leave behind a photo record of what we found and what we set. That documentation habit came out of commercial access-control work, and it carries onto every driveway gate we touch in Boulder City. If your gate has started to sag or scrape, call (844) 320-7587 and a live person will pick up, any hour. For the full range of fixes we handle beyond realignment, see our Gate Repair service.
When You Need Gate Realignment
Sagging and rubbing don’t fix themselves. In Boulder City we see realignment needs come from a few predictable places: the dry desert heat and the seasonal swing between the valley’s summer highs and cool winters work hinges and hardware loose over time, and the sandy, gravelly ground around a lot of driveways lets a hinge post creep out of plumb. Here’s what usually brings someone to call us.
- The gate drags or scrapes the ground. If you’ve started lifting the gate by hand to get it moving, the hinge side has dropped and the whole leaf needs re-hanging, not just oiled.
- It rubs the post or the other gate leaf. A swing gate that hits the frame at the latch side is usually out of square, and continuing to force it wears the hinges and the latch together.
- It won’t close flush or sits crooked. A gate that stops short, hangs a few inches low on one side, or leaves a gap at the top is telling you the hinge alignment or the opener’s limit setting is off.
- The opener strains or reverses mid-travel. A motor fighting a misaligned gate is a motor heading for premature failure. On LiftMaster and Elite operators in particular, a gate that’s been dragging for months often shows worn gears by the time we’re called.
- A gate that won’t line up across the driveway. Double swing gates drift out of alignment with each other, and the two leaves stop meeting cleanly at the center.
- After a vehicle bump, wind event, or a hard stop. Even a slow nudge to a driveway gate can pull the frame out of true enough that the opener no longer reads the stop points correctly.
Our Gate Realignment Process

Realignment is diagnosis first, tools second. Here’s how a visit runs, from the phone call to the record we leave in your hands.
- We name the price in writing before we start. Under Clause 1 of The Haven Standard, you get the flat price handed over before any work begins. No “call for a quote,” no surprise line items at the end.
- We inspect the posts, hinges, and frame. We check whether the gate itself is bent or whether the post has moved. Those are two different repairs, and the wrong one wastes your money. We measure plumb on the hinge post and photograph the readings.
- We adjust the hinges and hardware. Where the leaf has simply dropped, we reset the hinge plates, replace worn hardware, and re-hang the gate to true. On heavier gates we’ll check the frame for fatigue before trusting a simple hinge adjustment to hold.
- We reset the opener’s limit switches to the corrected travel. A realigned gate changes where the gate should stop, so the limit switch (the component that tells the motor where the gate starts and ends its run) has to be re-set to match. We photograph the new limit positions so the next technician has a starting point.
- We run the gate through a full open-and-close cycle. We test the safety photo-eye (the infrared beam that stops the gate if something crosses its path), confirm the gate reverses properly on obstruction, and cycle it several times to make sure it holds true.
- We leave a documented record. Before we go, you get a photo log of every adjustment and a written note of any part we replaced, including the part number. That record stays with your job file so nobody has to guess the next time.
We service nine major automation brands, including DoorKing and Mighty Mule, so whatever motor is already on your gate, we can work with it rather than pushing you toward a replacement.
Before
AfterGate Realignment Pricing in Boulder City
Here’s what realignment actually costs in Boulder City. Prices are ranges because the fix depends on what’s out of true, but you’ll have the exact flat price in writing before we start.
| Service | Typical Price Range |
|---|---|
| Hinge adjustment or realignment (gate re-hung to true) | $150 – $300 |
| Hinge hardware replacement + realignment | $200 – $380 |
| Post reset / re-plumb (frame or post pulled out of true) | $300 – $650 |
| Opener limit-switch re-set after realignment | $90 – $180 (often bundled with realignment) |
| Double-gate leaf realignment (both leaves) | $250 – $550 |
What pushes a job toward the higher end: a post that’s moved and needs re-setting in the ground, a heavy steel or ornamental gate versus an aluminum one, and gates that have been dragging long enough to wear the hinges. What keeps it low: a leaf that’s simply dropped at the hinge and needs a clean adjust-and-re-set with no new hardware.
The single biggest cost saver is catching it early. A gate that’s scraped for two months costs a hinge adjustment. The same gate left for a year often costs hinge replacement plus gear wear in the motor. If you’ve got a written estimate from another gate company and you’re unsure about it, we’ll review it at no cost; bring the paperwork and we’ll tell you plainly whether it’s the right fix.
FAQs – Gate Realignment

How much does gate realignment cost in Boulder City?
Most gate realignment jobs in Boulder City run between $150 and $450. A simple hinge adjustment sits at the low end; a post that needs re-plumbing or a full double-gate realignment lands higher. You’ll get the exact flat price in writing before any work starts, so there’s no guessing. Call (844) 320-7587 for a free estimate.
Can you come out today?
In most cases, yes. We keep the schedule open enough to fit same-day realignment, and a live person answers the phone 24 hours a day, so you’re never stuck in a voicemail loop waiting for a callback. Call (844) 320-7587 and we’ll tell you the soonest we can be there.
Is it cheaper to repair the gate or replace it?
Repair is almost always cheaper for a gate that’s simply out of alignment. Realignment fixes the existing gate and hardware for a fraction of what a new gate and install run, and it’s the right call unless the frame is bent, cracked, or rusted through. We’ll tell you plainly which side of that line your gate is on before you commit to anything.
How long does a realignment take?
Most single-gate realignments are finished in one visit, usually a couple of hours. Post resets and double-gate jobs take longer because there’s more to true up and re-test. When you call, we’ll give you a realistic window based on what you’re describing.
What You Get on Every Realignment Visit
Every realignment we do is covered by the 365-Day Done Right Promise. If the gate isn’t right within a full year of the work, we make it right at no additional charge. That’s one year, no fee, no argument. Under Clause 4 (Evidence on every job), you also get a documented photo record at no extra cost: what we found, what we set, what we replaced, left with you and filed in the job record. For the broader range of gate problems we handle beyond alignment, from openers to access control, see our home page and the full Gate Repair in Boulder City service.
Technicians are background-checked, arrive in uniform, and you get the name and photo before they show up, so you know who’s at your gate before they’re standing at it. Our technicians bring up to 12 years of hands-on experience to the job.
Book Your Gate Realignment

If your gate is dragging, scraping, or straining the opener, don’t wait for the next hard stop to make it worse. Call Vance Gate Repair Boulder City at (844) 320-7587 for a free estimate. You’ll get the flat price in writing before we start, a documented photo record when we leave, and a live person on the phone whenever you call. Estimates are free, and the sooner we see the gate, the simpler the fix.
Written by the team at Vance Gate Repair Boulder City, serving Boulder City.