Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateWhy Boulder City Homeowners Choose Ghost Controls Gate Repair
We provide independent Ghost Controls gate repair in Boulder City, and what makes our Ghost Controls work different is that we diagnose the whole system, not just the box. Ghost Controls builds DIY-designed openers that land on everything from light ornamental swing gates to heavy tube-steel double driveways, and the failures we see repeat in predictable patterns once you’ve worked on a few hundred of them. We’re not affiliated with or authorized by Ghost Controls; we’re an independent service provider that works across nine brands, which means we can tell you whether the control board, the swing arm, or the gate geometry is actually at fault. For Ghost Controls service in Boulder City, call (844) 320-7587.
Why Trust Vance Gate Repair Boulder City for Your Ghost Controls Gate Repair?
Our technicians have up to 12 years of experience with residential gate automation, and a good share of that has been spent on Ghost Controls systems: TSS1 single-swing kits, DTP1 dual-arm kits on double driveways, LTK latch and slide kits, and the AXS and KRB keypad and remote accessory sets. We know the harness layout, the battery and solar charging behavior, and the arm geometry well enough to skip the guesswork.
That familiarity matters most when a fault looks like a board problem but isn’t. Ghost Controls sells its control boards, receivers, actuators, and solar and battery components direct, so we source OEM-compatible parts for anything that touches the control logic, the receiver, or the actuator itself. For mounting hardware, batteries, and exterior wiring, quality aftermarket parts often hold up better in Boulder City’s heat and wind than the original hardware. We work warranty-safe: we don’t modify a control board or bypass a safety input, and we photograph every adjustment so you have a record if a warranty question ever comes up.
Under the Haven Standard, the price is written and handed to you before any work starts, and under Clause 4 every visit includes a documented photo record at no additional charge. 22,000+ gates repaired and installed since 2014, every one with a written price before the job began.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Common Ghost Controls Gate Repair Problems We Fix in Boulder City

Boulder City’s summers top 105°F and spring winds run 30-40 mph off the McCullough Range, and that combination accelerates the battery, wiring, and mount failures Ghost Controls owners call us about. Here’s what we see most.
- Control board under-volt faults from an aging 12V battery. The opener reports a fault or chatters instead of running, especially on DTP1 dual-arm kits where two arms draw on the same small battery. Owners often replace the board first; the battery is usually the real culprit.
- Too many accessories daisy-chained on one opener. Keypads, extra remotes, and interlocks wired onto the TSS1 harness draw more than the small solar or battery charge current can sustain. The system works for a while, then starts dropping functions.
- Swing arm mount plate and gate-bracket fatigue. On heavy tube gates, the arm bracket bends and the arm binds mid-travel. The opener stalls and it looks like a board problem, but the fault is mechanical.
- Transmitter and receiver pairing dropped after a battery change. Disconnecting or replacing the battery wipes the pairing on many Ghost Controls setups, and the remotes read as dead when they’re fine.
- Wiring chafing on exposed exterior runs. Solar panel or wall transformer leads rub against gate posts and frame edges in the wind, and the intermittent connection shows up as random stoppages that never repeat when you’re watching.
Before
AfterGhost Controls Parts & Our Repair-vs-Replace Approach
For Ghost Controls systems, the honest parts split is OEM for control boards, receivers, and actuators, and quality aftermarket for mounting hardware, batteries, and exterior wiring where it survives the desert better. We don’t claim to keep Ghost Controls parts in local stock; we identify the exact part from the model and serial on your unit, order it, and give you the written price before we schedule the return visit.
Repair versus replace gets decided on evidence, not on what’s easier to sell. When a control board on a cheaper single-arm kit is gone and the swing arm and hinges are also tired, a straight repair often isn’t the right long-term answer, and the diagnosis should say so plainly. When the board is the only failure and the gate geometry is sound, we repair it. Either way, you get the photo record and the reasoning. Call (844) 320-7587 and we’ll give you a free second opinion on any written estimate you’ve already received from another company.
Our Ghost Controls Service Process – Step by Step

- 1
Diagnosis. We read the fault at the control box, load-test the 12V battery, check solar charge current, and inspect the arm and gate brackets for bind. Every reading gets photographed.
- 2
Written scope and price. You get the flat price in writing before a tool comes out, itemized by part and labor, with the part numbers listed.
- 3
Repair or install. Board, receiver, actuator, battery, or arm replacement, plus wiring repair on exterior runs. Limit positions and arm alignment are set to the gate, not to a default.
- 4
Test and re-pair. We cycle the gate through full travel multiple times, re-pair every remote and keypad, and confirm the safety reverse and photo-eye behavior before we leave.
- 5
Warranty and record. The 365-Day Done Right Promise covers the completed work for a full year. You get the photo log and the part numbers in writing.
See the difference
Before
After
Before
After
Before
AfterGhost Controls Products We Service & Install in Boulder City
We service and install the Ghost Controls TSS1 single-swing kit for ornamental and rail gates, the DTP1 dual-swing kit for double driveway gates, and the LTK slide and latch series paired with the TSS arms. On the accessory side, we handle the AXS and KRB keypad and remote sets, solar panel and wall transformer wiring, and battery backup setups. If you’re weighing a swing gate conversion or adding a keypad to an existing system, call (844) 320-7587 for a free estimate and a written scope.
We Also Service These Brands

Ghost Controls is one of nine brands we work on. If your property has a LiftMaster, Mighty Mule, or DoorKing operator, we diagnose and repair those the same way. Being brand-blind means we aren’t steering you toward a replacement because it’s the only system we know.
FAQs – Ghost Controls Gate Repair Service in Boulder City
No. We’re an independent Ghost Controls service provider, not an authorized dealer or factory-authorized repair center. We work on Ghost Controls systems alongside eight other brands. That independence is why we can tell you honestly when a repair makes sense and when it doesn’t. Call (844) 320-7587 for a free estimate.
For control boards, receivers, and actuators, yes: we source OEM-compatible parts. For mounting hardware, batteries, and exterior wiring, quality aftermarket parts often hold up better outdoors in Boulder City’s heat and wind, and we’ll tell you which is which before you approve the work.
Most Ghost Controls repairs are completed in a single visit once the part is on hand. Battery, wiring, and re-pairing jobs are usually same-visit. Board or actuator replacements depend on parts availability, and we give you the written price and timeline before scheduling. Call (844) 320-7587 to get started.
We cover the TSS1 single-swing kit, the DTP1 dual-swing kit, the LTK slide and latch series, and the AXS and KRB keypad and remote accessory sets. If you’re not sure which model you have, the label on the control box identifies it.
Independent service doesn’t automatically void a Ghost Controls warranty, but modifying a board or bypassing a safety input can affect coverage. We work warranty-safe: no board modifications, no bypassed safety edges, and a photo record of every adjustment so you have documentation if a warranty question comes up.
Most Ghost Controls repairs in Boulder City run between $180 and $520, depending on whether it’s a battery and wiring job, a board or receiver replacement, or an arm and bracket repair. The price is written and handed to you before any work starts, so there’s no surprise invoice at the end. Call (844) 320-7587 for an exact quote; estimates are free.
Book Your Ghost Controls Service in Boulder City, NV

Whether your Ghost Controls opener is beeping, stalling, or dropping remotes, we’ll diagnose it, write the price, and leave you a documented record of what we found and fixed. Call Vance Gate Repair Boulder City at (844) 320-7587 for a free estimate and upfront pricing before any work begins. A live person answers 24/7.
Written by the team at Vance Gate Repair Boulder City.